This article applies to the Universal Repeater Solaris 300.
NOTE: Your N Router is compatible with any Operating System for setup, it only requires an internet browser to access it. (IE, Mozilla, Firefox, Chrome, Safari, etc.).
Please try the following steps to setup your Universal Repeater in your new router.
1. Connect you Nexxt Router Solaris 300 to your computer with the Ethernet cable from the Ethernet port to the one of the following LAN ports #1, #2, # in the Solaris 300. Is recommended port #1.
2. Open your default browser, type the IP address http://192.168.0.1 and press the keyboard "Enter" to access the main page of the router.
2. Open your default browser, type the IP address http://192.168.0.1 and press the keyboard "Enter" to access the main page of the router.
3. In the main page you will need the password. Please type in the password box “admin”.
4. Hit “Advanced” so you can access the configuration page of your router.
5. Go to “Wireless” Tab and then to “Wireless Extender”.
6. Choose “Universal Repeater” in the Extender Mode box.
7. Hit “Open Scan” and choose your wireless signal from your main modem.
8. It’s should appeared your Wireless signal name in the “SSID” box.
9. Choose your “Security Mode” is recommended both have the same security type.
10. Add the security password from the main modem in the “Key” box.
11. Scroll down and hit “Apply” the router will reboot and your Universal Repeater is complete.
6. Choose “Universal Repeater” in the Extender Mode box.
7. Hit “Open Scan” and choose your wireless signal from your main modem.
8. It’s should appeared your Wireless signal name in the “SSID” box.
9. Choose your “Security Mode” is recommended both have the same security type.
10. Add the security password from the main modem in the “Key” box.
11. Scroll down and hit “Apply” the router will reboot and your Universal Repeater is complete.