Welcome, Guest Login

Support Center

Nebula 300 Wireless Configuration

Last Updated: Dec 06, 2016 03:40PM COT

NOTE: Your N Router is compatible with any Operating System for setup, it only requires a internet browser to access it. ( IE, Mozilla, Firefox , Chrome, Safari, etc)


Please try the following steps to setup your router for Wireless (Wi-Fi) properly.

1. Connect your Nexxt router to your PC with an Ethernet cable on the LAN port (Yellow).
2. Verify that your PC has created the Local Area network on Network Connections.

3. Verify that the Firewall and Antivirus system are disabled to avoid any problems or restrictions.
4. Once all connected,  open your browser (IE,Mozilla,Firefox,etc) and enter the IP address of the router "" by default. This will prompt you to type some credentials to access the router webpage.

5. Use "admin" as password. 

6. On the main screen, click on “Advanced” in the middle of the webpage.

7. On “Wireless”, click on “Wireless Basic Settings”.

8.  Verify or modify your Wireless network name (Primary SSID) and be sure that is marked on “enable Wireless Function”.

9. Check the wireless channels (Channels 6 and 2 – recommended).

10. Click on “Ok” to save the changes. 

11. On “Wireless”, click on “Wireless Security”.
12. Select the Security Mode (for example WPA2-PSK), WPA Algorithms on “AES” and on the “Key”, type the password for your Wireless network.

13. Click on “Ok” to save the changes. 

14. Reboot router, you can reboot your router on "Tools" on the Reboot router option

15. Connect your Nexxt router to your ISP modem with an Ethernet Cable on the WAN port (Blue).  
See related videos about wireless settings: 
Wireless setup for Nebula 300: 

Contact Us

  • Email Us
  • Live Chat!
[email protected]
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found