Welcome, Guest Login

Support Center

Cosmos 1200 - Configuration Guide Universal Repeater

Last Updated: Nov 30, 2016 04:00PM COT
NexxtLogo
 
This article only apply for the Cosmos 1200.

N
OTE: Your N Router is compatible with any Operating System for setup, it only requires a internet browser to access it. ( IE, Mozilla, Firefox , Chrome, Safari, etc).

 

Universal Repeater Configuration Guide
 

NOTE: In case you are going to use a laptop, please disconnect it from any wireless connection, and work directly with the Cosmos 1200.

STEPS: 

1. Connect one end of the Ethernet cable to the Cosmos 1200 and the other end to your computer.
2. Press the RESET button for 30 seconds and release. 
3. Make sure your firewall and antivirus are disable in case they block the configuration page.
4. After the reset and all the connection are done, open your browser and enter the following IP address in the search bar 192.168.0.1 this will let you access to the router webpage. 

 
 
5. When the Login page is available please enter the password "admin" to access the router configuration page.
 
 
6. Select the "Advanced" link to access the main configuration page. 
 
 
Since the Cosmos 1200 by default he will be displaying all the bands (2.4GHz, 5GHz and Guest Network) in this section we´re going to disable (5GHz and Guest Network).

7. Select the "Wireless" tab in the top. You will see the "Basic Settings". In the "Band" drop list, choose the "5GHz" band and disable it. Then hit "Save" 

 
 



8. Now go to "Guest Network" section, and disable all the bands there, the "2.4GHz and 5GHz". Remember to save each configuration by pressing "Save" 
 



 

9. Select "Security" in the left side of the list. We are going to configure the Wireless Signal in the Cosmos 1200. In this part we are going to use the "Band 2.4GHz".
NOTE: Is the same process for the 5GHz in case you want to use that band. 

 
10. Choose "WPA-PSK/WPA2-PSK" then "WPA-PSK" in the "Authentication Type""AES" in the "Cipher Type", and add the password you want in the "Security Key" box. After that hit "Save"
 

11. In the left side list, choose Wireless Extender. As we say before, we are going to use the band 2.4GHz, is the same steps for the 5GHz if you want to use it. 
12. Band choose "2.4 GHz".
13. MODE choose "Universal Repeater".
14. Click the box "Open Scan". Then choose your main wireless signal. (The one you want to repeat.)
15. Remote SSID This will show the name of the remote wireless signal.
16. Channel will automaticaly set.
17. Remote MAC Address will automaticaly set the main wireless MAC.
18. Security Mode by default the Cosmos1200 will automatically select the security type that the main router is using. This could be "WEP (SHARED)", WPA-PSK, WPA2-PSK or MIXED WPA-PSK/WPA2-PSK.  
19. Authentication Type choose "WPA2-PSK"
20. Cipher Type choose "TKIP+AES".
21. Security Key type the security password of the main wireless router. 
22. Hit "Save"

 
 

17. In the next windows choose "reboot" to complete the configuration.
 
18. Now your Cosmos 1200 is configured. 

Contact Us

  • Email Us
  • Live Chat!
techsupport@nexxtsolutions.com
http://assets3.desk.com/
false
assistly
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete