Welcome, Guest Login

Support Center

Viking 150 WDS Mode

Last Updated: Jan 13, 2015 02:43PM COT
NexxtLogo
 
This article applies for Viking150 Router. 

NOTE: Your N Router is compatible with any Operating System for setup, it only requires a internet browser to access it. ( IE, Mozilla, Firefox , Chrome, Safari, etc) 

 
WDS Requirements
 * * * (PLEASE READ CAREFULLY BEFORE PROCEED) * * *
 
1. All routers on WDS should have the same firmware and same router model (If you are using a router that ends with U1, all repeaters needs ONLY to be ending with U1, same with U2 router model. Different router models together DOES NOT work on WDS). Also make sure is the latest firmware you are using if posible.

2. SSID, Channels and Extension Channel should also be the same on all routers on the network.

3. The IP address of the all wireless routers must be different but have to be within the range of the main router. For example: RouterA IP: 192.168.0.10; RouterB IP: 192.168.0.11.

4. While setting up WDS, the password and security for Wireless should be the same. This will allow the routers to be used in a roaming mode. The password for router settings webpage could be different on each device.

5. DHCP server must be disable for secondary routers. Only the Main router will have the DHCP enable.

6. The routers IP addresses must be outside the DHCP pool.

7. Reboot routers after the configuration is done.


 

These are the steps to configure a WDS system with a Viking 150 router:

1. Make sure your router is connected via a network cable to your computer and is connected to the       current outlet or USB port using the power cord.
 
2. Open your preferred browser and enter the address http://192.168.0.1.
 
3. Use "admin" for the username and password.
 

4. In the menu that appears on your right, select "Wireless".

5. Select “Enable WDS Bridging”.

6. Now you will click on "Survey" and it will appear a list of AP devices to connect to. Select the one you want to be your main router and click on "Connect".

 

7. The spaces in blank will be filled in. Now select the same Security details and password as in the main router. Scroll down and click on "Save".

8. Reboot your device. In the legend that appears over the Save button, click on "click here". Or from the menu select "System Tools" and reboot from there.


WDS Configurations Video Tutorial
 

Contact Us

  • Email Us
  • Live Chat!
techsupport@nexxtsolutions.com
http://assets1.desk.com/
false
assistly
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete