Welcome, Guest Login

Support Center

Acrux 300: Port Fowarding

Last Updated: Jan 29, 2015 11:40AM COT
NexxtLogo
 
 
This article applies for Acrux300 Router. 


NOTE: Your N Router is compatible with any Operating System for setup, it only requires a internet browser to access it. ( IE, Mozilla, Firefox , Chrome, Safari, etc) 

Here are the steps to setup the Port Forwarding on your Router:

 
1. Create your internal server, make sure the LAN users can access these servers and known related service port. For example, Web server’s port is 80; FTP is 21; SMTP is 25 and POP3 is 110. One case is the Slingbox port that is 5001. For other services such as IP Cameras, the port was given by device and port can be modified on the device itself by customer.
2. Open your browser (IE,Mozilla,Firefox,etc) and enter the IP address of the router "192.168.0.1" by default. This will prompt you to type some credentials to access the router webpage.

3.  Use "admin" as user and password.

 

4. On your router’s web click on “Forwarding".

5. Select “Virtual Servers".


6. Click on "Add New". 



 
7.  Input the external service port given by the Router, for example, 80 or in your case, 5001.

8.  The Internal Service Port number of the PC running the service application. You can leave it blank if the Internal Port is the same as the Service Port, or enter a specific port number whenService Port is a single one.
 
9.  Input the internal server’s IP address. If your Web server’s IP address is 192.168.0.10, please input it to be declared on your DHCP internal table. 
 
10.  In “Protocol” used for this application, either TCP, UDP, orAll (all protocols supported by the Router).

11.  On “Status”, select "Enabled".
 
12.  In Common Service Port - Some common services already exist in the pull-down list.
 
 
 
13.  Click on “Save" to activate the settings.
 


Open Port Triggering

Is a configuration option on a NAT-enabled router that allows a host machine to dynamically and automatically forward a specific port back to itself. Port triggering opens an incoming port when your computer is using a specified outgoing port for specific traffic.


1.   Add the external port that you need to configure.
 
2.    In “Trigger Port” use the protocol used for Trigger Ports, either TCP,UDP, or All (all protocols supported by the Router).
 
3.  On Incoming Port  use the port or port range used by the remote system when it responds to the outgoing request. A response using one of these ports will be forwarded to the PC which triggered this rule. You can input at most 5 groups of ports (or port sections). Every group of ports must be separated with ",", for example, 2000-2038, 2046, 2050-2051, 2085, 3010-3030. 

4.  On Incoming Protocol use the protocol used for an Incoming Port, either TCP, UDP, or ALL (all protocols supported by the Router).

5.   On Status place it as “Enabled”.

6.  On Common Applications there are some popular applications already listed in the pull-down list of Incoming Protocol.

 

 
7.   Click on “save" to activate the settings.

Contact Us

  • Email Us
  • Live Chat!
techsupport@nexxtsolutions.com
http://assets0.desk.com/
false
assistly
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete