Welcome, Guest Login

Support Center

Nebula 150: Wireless Setup

Last Updated: Feb 23, 2016 01:25PM COT
NexxtLogo
 
This article applies for the model listed below: Nebula 150 (ARN01154U1 & ARN01154U2).
 


 
NOTE: Your N Router is compatible with any Operating System for setup, it only requires a internet browser to access it. ( IE, Mozilla, Firefox , Chrome, Safari, etc).


Here are the steps to setup your router for Wireless (Wi-Fi) properly.

1. Connect your Nexxt router to your PC with an Ethernet cable on the LAN port (Yellow).
 
2. Connect your Nexxt router to your ISP modem with an Ethernet Cable on the WAN port (Blue).

3. Verify that your PC has created the Local Area network on Network Connections.

4. Verify that the Firewall and Antivirus system are disabled to avoid any problems or restrictions.
 
5. Once all connected,  open your browser (IE,Mozilla,Firefox,etc) and enter the IP address of the router "192.168.0.1" by default. This will prompt you to type some credentials to access the router webpage.


Please go to the link that belongs to your router model:
 
 

 

a. Use "admin" as user and password. 

b. On the menu, click on “WLAN Settings”.

c. On WLAN Settings, click on “Basic Settings”.
 
 
 
d.  Verify or modify your Wireless network name (SSID) and be sure that is marked on “enable” on  “Broadcast (SSID)”
.

e. Check the wireless channels (Channels 6 and 2 – recommended).

f. Click on “Apply” to save the changes.

g. On WLAN Settings, click on “Security Settings”.

 
 
h. Select the Security Type (for example WPA2-Personal) and on the Passphrase, type the password for your Wireless network.
 

i.  Click on “Apply” to save the changes.  

j.  Reboot router, you can reboot your router on "System Tools" on the Reboot router option.



 


a. Use "admin" as password. 

b. On the main screen, click on “Advanced Settings” in the middle of the webpage.


c. On “Wireless Settings”, click on “Wireless Basic Settings”.

d.  Verify or modify your Wireless network name (Primary SSID) and be sure that is marked on “enable Wireless Function”.

e. Check the wireless channels (Channels 6 and 2 – recommended).

f. Click on “Ok” to save the changes.


g. On “Wireless Settings”, click on “Wireless Security”.

h. Select the Security Mode (for example WPA2-PSK), WPA Algorithms on “AES” and on the “Key”, type the password for your Wireless network.


i. Click on “Ok” to save the changes. 

j. 
Reboot router, you can reboot your router on "System Tools" on the Reboot router option.

 

NOTE: If those steps does not work, you can UPGRADE your router. Follow this link for more details about firmware upgrade: How to upgrade my router.

Contact Us

  • Email Us
  • Live Chat!
techsupport@nexxtsolutions.com
http://assets0.desk.com/
false
assistly
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete