Welcome, Guest Login

Support Center

How to setup your Wireless adapter on AP Mode *NEW*

Last Updated: Jul 23, 2014 05:06PM COT
NexxtLogo

This article applies for USB adapters models available for Nexxt Solutions.
 

              
 
Here are the steps to enable a USB Wireless adapter as an "AP (Access point) mode". To enable this feature, you must need to install the Wireless adapter software that comes with your CD installation software:

1. Right click on the UI Icon on the taskbar of your desktop and select "Switch to AP Mode".


2. When sucessfully switch to AP mode, this will prompt you to this screen below.


3. Click on AP Config to setup the AP mode.


4. Select the Channel for your AP, then click "Next" to select the "Encryption Type" for your AP, you can choose "open" and "not use" to share your wireless network without password or choose "WPA-PSK" and "AES" to set a password for your wireless network.


5. Now you have finish your settings, you can try to use other wireless device to connect to the signal of your AP and go to the internet.

Contact Us

  • Post a Public Question
  • Email Us
  • Live Chat!
techsupport@nexxtsolutions.com
http://assets3.desk.com/
false
assistly
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete